Ignis F27

Ignis error code F27 indicates: Ignis LTE Top-Loader & TuttoinUno Front-Loader Washing Machine: Drum reversing motor relay contact stuck F27; motor can rotate in only one direction due to welded relay contacts..

The primary root cause for Ignis code F27 is: On Ignis washing appliances: High inductive arc discharge during drum reversal under heavy laundry load welding reversing relay contacts on PCB..

To resolve error code F27: De-energize machine. Tap relay casing lightly or measure contact continuity with power off (normally open contacts must read infinite ohms). Replace PCB relay. Hold Start/Cancel button for 5 seconds until indicator light turns solid, switch off, and turn knob to 0.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Ignis code F27 persists, the physical component causing On Ignis washing appliances: High inductive arc discharge during drum reversal under heavy laundry load welding reversing relay contacts on PCB. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.