Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bompani A08
FAQ TREEWhat does error code A08 mean on a Bompani appliance?
Bompani error code A08 indicates: Bompani AquaStop Fully Integrated & Freestanding Eco-Wash Dishwasher: Operational diagnostic fault code A08 signaled by internal electronics. Water inlet flowmeter impeller reed switch signal missing during active fill cycle.
What is the root cause of Bompani error code A08?
The primary root cause for Bompani code A08 is: On Bompani kitchen suites engineered with synchronous wash pump with run capacitor, 1800W flow-through heater (26-28 Ω), pneumatic pressure switch, optical turbidity sensor, and AquaStop tray switch: Flowmeter turbine jammed by sand grain or limescale, reed switch glass capsule cracked, or harness open Multimeter diagnostic parameter: flowmeter pulses at ~200 pulses/liter; reed switch toggles cleanly between 0.0 Ω and infinite resistance..
How do I fix or resolve Bompani error code A08?
To resolve error code A08: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: blow air through water jacket while measuring resistance across reed switch pins to verify pulsing contact. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Switch appliance off. Press and hold Start/Reset button for 4 seconds while powering on, release when LED flashes rapidly, clearing saved cycle errors.
Is it safe to clear Bompani error code A08 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bompani code A08 persists, the physical component causing On Bompani kitchen suites engineered with synchronous wash pump with run capacitor, 1800W flow-through heater (26-28 Ω), pneumatic pressure switch, optical turbidity sensor, and AquaStop tray switch: Flowmeter turbine jammed by sand grain or limescale, reed switch glass capsule cracked, or harness open Multimeter diagnostic parameter: flowmeter pulses at ~200 pulses/liter; reed switch toggles cleanly between 0.0 Ω and infinite resistance. must be inspected or replaced.
How do I test electrical resistance for Bompani code A08 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Bompani code A08?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?