Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Scholtès A08
FAQ TREEWhat does error code A08 mean on a Scholtès appliance?
Scholtès error code A08 indicates: Scholtès LTE / LPE Maxi Plate 14-Place Integrated Dishwasher: Diagnostic fault code A08 registered by the microcomputer controller. Water heating timeout / heating element open circuit (~28 Ω).
What is the root cause of Scholtès error code A08?
The primary root cause for Scholtès code A08 is: On Scholtès appliances engineered with EVO-3 / Arcadia hydraulic control platform with variable-frequency wash pump, active siphonage detection, and calibrated NTC immersion thermistor: flow heater element open circuit Metrological tolerance verification: nominal 26.0 Ω to 28.5 Ω (2000W / 230V)...
How do I fix or resolve Scholtès error code A08?
To resolve error code A08: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure resistance across flow heater element terminals (expected ~28 Ω). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold the P (Program) and Start buttons simultaneously for 4 seconds until all LEDs illuminate and the machine emits a beep, then turn selector to 0 to cancel the error.
Is it safe to clear Scholtès error code A08 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Scholtès code A08 persists, the physical component causing On Scholtès appliances engineered with EVO-3 / Arcadia hydraulic control platform with variable-frequency wash pump, active siphonage detection, and calibrated NTC immersion thermistor: flow heater element open circuit Metrological tolerance verification: nominal 26.0 Ω to 28.5 Ω (2000W / 230V).. must be inspected or replaced.
How do I test electrical resistance for Scholtès code A08 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Scholtès code A08?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



