Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Bosch E4
FAQ TREEWhat does error code E4 mean on a Bosch appliance?
Bosch error code E4 indicates: Bosch Serie 6 / Serie 8 FlexInduction & PerfectFry Induction Cooktop: Mains under-voltage detected E4; AC line voltage drops below 185V AC under load during active heating..
What is the root cause of Bosch error code E4?
The primary root cause for Bosch code E4 is: On Bosch hobs: Loose terminal screw on terminal block, undersized house wiring cross-section (< 2.5 mm²), or severe grid voltage drop..
How do I fix or resolve Bosch error code E4?
To resolve error code E4: Inspect mains terminal block connections for loose clamping screws or scorching. Measure supply voltage under load (> 207V AC required). Turn off all cooking zones, switch off mains circuit breaker for 30 seconds, restore power, hold Key lock for 4 seconds.
Is it safe to clear Bosch error code E4 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Bosch code E4 persists, the physical component causing On Bosch hobs: Loose terminal screw on terminal block, undersized house wiring cross-section (< 2.5 mm²), or severe grid voltage drop. must be inspected or replaced.
How do I test electrical resistance for Bosch code E4 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test PTC Heater Pellet / Pulse Solenoid / Microswitch Contacts across Across PTC heater terminals on lock bezel; switch contact reads <0.2Ω when locked. Expected nominal reading is 800Ω–1.5kΩ (PTC terminals L-N) / 60Ω–120Ω (Pulse Solenoid). Tolerance: ±15%. Switch contacts must read open (OL) when unlocked and 0.0Ω–0.2Ω when fully latched..
What safety protocol must be followed before servicing Bosch code E4?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



