Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Candy E20
FAQ TREEWhat does error code E20 mean on a Candy appliance?
Candy error code E20 indicates: Candy RapidÓ / Smart Pro / GrandÓ Vita Inverter Washer: Electronic pressure sensor calibration fault E20; signal frequency received from the analog pressure transducer is out of valid bounds..
What is the root cause of Candy error code E20?
The primary root cause for Candy code E20 is: On Candy washing machines powered by Speed-Drive Inverter brushless motor, Smart Touch NFC / hOn Wi-Fi connectivity, and GIAS Cuore electronic platform: Blocked pressure tube, punctured silicone diaphragm, or defective oscillator in electronic pressure switch (~25.6 kHz empty)..
How do I fix or resolve Candy error code E20?
To resolve error code E20: Inspect rubber pressure hose for pinholes or splits. Blow through tube towards tub to clear compression dome. Measure sensor output frequency (~25.6 kHz empty). Turn dial to Off, press and hold Start/Pause and Extra Rinse simultaneously for 5 seconds until display flashes '888', then power cycle.
Is it safe to clear Candy error code E20 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Candy code E20 persists, the physical component causing On Candy washing machines powered by Speed-Drive Inverter brushless motor, Smart Touch NFC / hOn Wi-Fi connectivity, and GIAS Cuore electronic platform: Blocked pressure tube, punctured silicone diaphragm, or defective oscillator in electronic pressure switch (~25.6 kHz empty). must be inspected or replaced.
How do I test electrical resistance for Candy code E20 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Candy code E20?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



