Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Rosieres E20
FAQ TREEWhat does error code E20 mean on a Rosières appliance?
Rosières error code E20 indicates: Rosières RLF / RLE Pro Inverter Washing Machine: Electronic pressure sensor calibration fault E20; signal frequency received from the analog pressure transducer is out of valid bounds..
What is the root cause of Rosières error code E20?
The primary root cause for Rosières code E20 is: On Rosières washing machines powered by Pro Inverter quiet direct drive system, GIAS electronic platform, and balance sensor control: Blocked pressure tube, punctured silicone diaphragm, or defective oscillator in electronic pressure switch (~25.6 kHz empty)..
How do I fix or resolve Rosières error code E20?
To resolve error code E20: Inspect rubber pressure hose for pinholes or splits. Blow through tube towards tub to clear compression dome. Measure sensor output frequency (~25.6 kHz empty). Set selector to stop position, press and hold Start and Spin buttons for 5 seconds until warning lights blink sequentially, then turn off.
Is it safe to clear Rosières error code E20 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Rosières code E20 persists, the physical component causing On Rosières washing machines powered by Pro Inverter quiet direct drive system, GIAS electronic platform, and balance sensor control: Blocked pressure tube, punctured silicone diaphragm, or defective oscillator in electronic pressure switch (~25.6 kHz empty). must be inspected or replaced.
How do I test electrical resistance for Rosières code E20 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Rosières code E20?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



