Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Rosieres E22
FAQ TREEWhat does error code E22 mean on a Rosières appliance?
Rosières error code E22 indicates: Rosières RLF / RLE Pro Inverter Washing Machine: Siphoning drain detection E22; water level drops continuously during active wash fill cycle without pump activation..
What is the root cause of Rosières error code E22?
The primary root cause for Rosières code E22 is: On Rosières washing machines featuring Pro Inverter quiet direct drive system, GIAS electronic platform, and balance sensor control: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal..
How do I fix or resolve Rosières error code E22?
To resolve error code E22: Ensure top of drain hose bend is suspended between 65 cm and 100 cm above floor level. Use anti-siphon curved elbow and provide air gap in standpipe. Set selector to stop position, press and hold Start and Spin buttons for 5 seconds until warning lights blink sequentially, then turn off.
Is it safe to clear Rosières error code E22 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Rosières code E22 persists, the physical component causing On Rosières washing machines featuring Pro Inverter quiet direct drive system, GIAS electronic platform, and balance sensor control: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal. must be inspected or replaced.
How do I test electrical resistance for Rosières code E22 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Rosières code E22?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



