Arthur Martin E22

Arthur Martin error code E22 indicates: Arthur Martin Electrolux AWF Series / Silence Plus Washer: Draining anomaly during drying cycle E22 on washer-dryer; condensate water accumulates in lower chamber..

The primary root cause for Arthur Martin code E22 is: On Arthur Martin (Arthur Martin Electrolux AWF Series / Silence Plus Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor..

To resolve error code E22: Flush drying condenser duct with warm water to clear lint agglomerations. Check drain pump continuous operation under heated cycle. Hold Départ/Pause and Option buttons firmly for 5 seconds until the red indicator extinguishes and service memory resets.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Arthur Martin code E22 persists, the physical component causing On Arthur Martin (Arthur Martin Electrolux AWF Series / Silence Plus Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.