Faure E22

Faure error code E22 indicates: Faure FWG / FWF Series / Magic'45 Compact Washer: Draining anomaly during drying cycle E22 on washer-dryer; condensate water accumulates in lower chamber..

The primary root cause for Faure code E22 is: On Faure (Faure FWG / FWF Series / Magic'45 Compact Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor..

To resolve error code E22: Flush drying condenser duct with warm water to clear lint agglomerations. Check drain pump continuous operation under heated cycle. Press and hold Départ/Pause and Annulation buttons for 6 seconds until all status indicators flash synchronously and clear fault memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faure code E22 persists, the physical component causing On Faure (Faure FWG / FWF Series / Magic'45 Compact Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.