Electrolux E22

Electrolux error code E22 indicates: Electrolux PerfectCare 600/700/800 UltraCare Washer: Draining anomaly during drying cycle E22 on washer-dryer; condensate water accumulates in lower chamber..

The primary root cause for Electrolux code E22 is: On Electrolux (Electrolux PerfectCare 600/700/800 UltraCare Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor..

To resolve error code E22: Flush drying condenser duct with warm water to clear lint agglomerations. Check drain pump continuous operation under heated cycle. Hold Start/Pause and Delay Start together for 5 seconds on program position 10 until the acoustic chime sounds and display resets to 0:00.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Electrolux code E22 persists, the physical component causing On Electrolux (Electrolux PerfectCare 600/700/800 UltraCare Washer) models: Lint clogging condenser duct drain, intermittent drain pump thermal trip during prolonged drying heat, or faulty pressure signal under warm vapor. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.