Faure E32

Faure error code E32 indicates: Faure FWG / FWF Series / Magic'45 Compact Washer: Electronic pressure sensor calibration error E32 during drain phase; calibration frequency does not stabilize..

The primary root cause for Faure code E32 is: On Faure (Faure FWG / FWF Series / Magic'45 Compact Washer) models: Residual water remaining in tub due to slow draining, partial blockage in air bell holding trapped pressure, or defective pressure transducer..

To resolve error code E32: Drain tub completely manually via emergency drain plug. Disconnect pressure hose to equalize atmospheric pressure, reconnect tightly. Press and hold Départ/Pause and Annulation buttons for 6 seconds until all status indicators flash synchronously and clear fault memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faure code E32 persists, the physical component causing On Faure (Faure FWG / FWF Series / Magic'45 Compact Washer) models: Residual water remaining in tub due to slow draining, partial blockage in air bell holding trapped pressure, or defective pressure transducer. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.