Iberna E22

Iberna error code E22 indicates: Iberna ILF / EcoTime Pro Inverter Washing Machine: Siphoning drain detection E22; water level drops continuously during active wash fill cycle without pump activation..

The primary root cause for Iberna code E22 is: On Iberna washing machines featuring reliable GIAS compact micro-controller, high-efficiency wash group, and fast-response NTC thermistors: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal..

To resolve error code E22: Ensure top of drain hose bend is suspended between 65 cm and 100 cm above floor level. Use anti-siphon curved elbow and provide air gap in standpipe. Move program selector to Stop, hold Start/Pause and Spin keys together for 5 seconds until status LEDs extinguish, then restart.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Iberna code E22 persists, the physical component causing On Iberna washing machines featuring reliable GIAS compact micro-controller, high-efficiency wash group, and fast-response NTC thermistors: Drain hose installed too low (<65 cm height), drain hose pushed too far into standpipe creating airtight siphon seal. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.