Castor E34

Castor error code E34 indicates: Castor CWF Series / Master Lavatrice Front Load Washer: Level incongruence alarm E34; mismatch between analog sensor frequency and anti-overflow safety switch..

The primary root cause for Castor code E34 is: On Castor (Castor CWF Series / Master Lavatrice Front Load Washer) models: Anti-overflow mechanical contact stuck open or closed, analog sensor calibration drifted, or electrical noise on analog signal line..

To resolve error code E34: Test continuity of mechanical anti-overflow switch contacts (should be closed at rest < 1 Ω). Verify analog pressure sensor frequency (~43.5 Hz empty). Hold Start and Reset keys for 5 seconds until the display clears the alarm code and restores standby status.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Castor code E34 persists, the physical component causing On Castor (Castor CWF Series / Master Lavatrice Front Load Washer) models: Anti-overflow mechanical contact stuck open or closed, analog sensor calibration drifted, or electrical noise on analog signal line. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.