Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Daewoo E-07
FAQ TREEWhat does error code E-07 mean on a Daewoo appliance?
Daewoo error code E-07 indicates: Daewoo Built-in Convection Oven & KOR Combi Microwave: Diagnostic fault code E-07 registered by the microcomputer controller. Microwave turntable drive motor electrical open circuit, gear stripper, or mechanical platter bind.
What is the root cause of Daewoo error code E-07?
The primary root cause for Daewoo code E-07 is: On Daewoo appliances engineered with convective hot air turbine, cavity PT1000/NTC thermistor probe, high-voltage transformer/magnetron assembly, and safety door interlock switches: Synchronous turntable drive motor coil burned open, food spills cementing drive bushing, or stripped plastic gear train Metrological tolerance verification: turntable synchronous gear motor coil nominal resistance 2.5 kΩ to 3.5 kΩ at 230V AC (5/6 RPM)..
How do I fix or resolve Daewoo error code E-07?
To resolve error code E-07: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: remove bottom access cover; unplug turntable motor terminals and measure coil resistance with multimeter (spec: 2.5-3.5 kΩ). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Clear oven cavity. Press Stop/Clear key twice. Disconnect mains plug or circuit breaker for 60 seconds. Reconnect, then touch and hold Clock and Auto Cook keys simultaneously for 5 seconds until a melodic chime confirms control board calibration reset.
Is it safe to clear Daewoo error code E-07 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Daewoo code E-07 persists, the physical component causing On Daewoo appliances engineered with convective hot air turbine, cavity PT1000/NTC thermistor probe, high-voltage transformer/magnetron assembly, and safety door interlock switches: Synchronous turntable drive motor coil burned open, food spills cementing drive bushing, or stripped plastic gear train Metrological tolerance verification: turntable synchronous gear motor coil nominal resistance 2.5 kΩ to 3.5 kΩ at 230V AC (5/6 RPM). must be inspected or replaced.
How do I test electrical resistance for Daewoo code E-07 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Daewoo code E-07?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?