Daewoo F6

Daewoo error code F6 indicates: Daewoo DDW Series Ultra Clean AquaStop Dishwasher: Diagnostic fault code F6 registered by the microcomputer controller. Water softener salt regeneration solenoid valve coil electrical circuit open or driver triac failed.

The primary root cause for Daewoo code F6 is: On Daewoo appliances engineered with hydraulic high-pressure wash pump, triple fine-mesh sump filter, electronic overflow float switch, and inline flow-through heating element: Solenoid coil open circuit due to thermal stress, wiring harness pinched in base, or salt chamber water leakage onto terminals Metrological tolerance verification: water softener regeneration valve solenoid coil resistance 3.5 kΩ to 4.2 kΩ at 20°C..

To resolve error code F6: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: disconnect wiring harness at salt container valve and measure coil resistance with multimeter (spec: 3.5-4.2 kΩ; replace if open). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Switch machine off. Press and hold Program and Delay buttons together while pressing Power On. Hold for 4 seconds until status LEDs flash rapidly. Press and hold Start/Pause for 3 seconds until the drain pump activates for a 30-second cycle to purge water and clear error lock.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Daewoo code F6 persists, the physical component causing On Daewoo appliances engineered with hydraulic high-pressure wash pump, triple fine-mesh sump filter, electronic overflow float switch, and inline flow-through heating element: Solenoid coil open circuit due to thermal stress, wiring harness pinched in base, or salt chamber water leakage onto terminals Metrological tolerance verification: water softener regeneration valve solenoid coil resistance 3.5 kΩ to 4.2 kΩ at 20°C. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.