De Dietrich Er13

De Dietrich error code ER13 indicates: De Dietrich ICS (Intelligent Cooking System) / Fascination / Corium Pyrolytic Oven: Circular convection fan heating element open circuit Er13; convection forced air mode blows air without heating..

The primary root cause for De Dietrich code ER13 is: On De Dietrich built-in ovens featuring ICS sensor-guided automated culinary cooking, PT500 platinum thermal probe (~540 Ω at 20°C), and 480°C Pyro-Turbo cleaning: Burned-out circular calrod heating element surrounding the rear convection fan (~25–32 Ω)..

To resolve error code ER13: Disconnect power and remove rear internal fan shroud inside oven cavity. Measure resistance across circular element terminals (~25–32 Ω). Replace element. Rotate rotary knob to zero, disconnect power at the master breaker panel for 90 seconds, re-engage and validate time on the ICS interface.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if De Dietrich code ER13 persists, the physical component causing On De Dietrich built-in ovens featuring ICS sensor-guided automated culinary cooking, PT500 platinum thermal probe (~540 Ω at 20°C), and 480°C Pyro-Turbo cleaning: Burned-out circular calrod heating element surrounding the rear convection fan (~25–32 Ω). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.