Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Electroline E18
FAQ TREEWhat does error code E18 mean on a Electroline appliance?
Electroline error code E18 indicates: Electroline EW / ProWash Electronic Front-Load Washing Machine: Diagnostic fault code E18 registered by the microcomputer controller. Drain pump cycling without evacuating; back-siphoning or standpipe flow restriction detected.
What is the root cause of Electroline error code E18?
The primary root cause for Electroline code E18 is: System architecture (Electroline digital control platform, universal commutator motor, 12 kΩ NTC sensor, and electronic pressure switch): drain hose inserted too deep into wall standpipe, check valve stuck closed, or wall drain choked. Metrological test specification: drain standpipe height 65 cm to 100 cm; free air gap required; backpressure < 0.15 bar..
How do I fix or resolve Electroline error code E18?
To resolve error code E18: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: adjust hose hook height to between 65cm and 100cm; ensure anti-siphon vent adapter is fitted. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: turn selector to Off, press and hold Start/Pause for 5 seconds while turning program dial one click clockwise, release when LEDs illuminate, then turn to Off.
Is it safe to clear Electroline error code E18 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Electroline code E18 persists, the physical component causing System architecture (Electroline digital control platform, universal commutator motor, 12 kΩ NTC sensor, and electronic pressure switch): drain hose inserted too deep into wall standpipe, check valve stuck closed, or wall drain choked. Metrological test specification: drain standpipe height 65 cm to 100 cm; free air gap required; backpressure < 0.15 bar. must be inspected or replaced.
How do I test electrical resistance for Electroline code E18 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Electroline code E18?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



