Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Elica E14
FAQ TREEWhat does error code E14 mean on a Elica appliance?
Elica error code E14 indicates: Elica NikolaTesla (One / Switch / Prime / Flame / Libra / Fit / Unplugged) Aspirating Induction Cooktop: Diagnostic fault code E14 registered by the microcomputer controller. Aspirating grease condensate overflow reservoir active..
What is the root cause of Elica error code E14?
The primary root cause for Elica code E14 is: On Elica appliances engineered with central high-flow brushless aspiration motor, intelligent air quality sensing, dual-zone bridge induction generator, and multi-slider capacitive touch interface: liquid condensate tray full in chassis. Metrological tolerance verification: drain pump synchronous motor coil nominal 165 Ω to 180 Ω (230V AC)..
How do I fix or resolve Elica error code E14?
To resolve error code E14: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure drain pump coil resistance across terminals (expected ~170 Ω). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Power down the dedicated cooktop circuit breaker for 60 seconds. Restore power, wait for display self-test cycle to conclude, then touch and hold the Key Lock (padlock icon) sensor for 5 seconds until an audible confirmation tone sounds. For filter saturation reset, touch and hold the Filter icon for 3 seconds while in standby.
Is it safe to clear Elica error code E14 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Elica code E14 persists, the physical component causing On Elica appliances engineered with central high-flow brushless aspiration motor, intelligent air quality sensing, dual-zone bridge induction generator, and multi-slider capacitive touch interface: liquid condensate tray full in chassis. Metrological tolerance verification: drain pump synchronous motor coil nominal 165 Ω to 180 Ω (230V AC). must be inspected or replaced.
How do I test electrical resistance for Elica code E14 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Elica code E14?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?