Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: FAGOR I20
FAQ TREEWhat does error code I20 mean on a FAGOR appliance?
FAGOR error code I20 indicates: Fagor Dishwasher beeps and stops with fault code 'i20'; dirty water remains pooled in the bottom of the tub..
What is the root cause of FAGOR error code I20?
The primary root cause for FAGOR code I20 is: Drainage timeout: drain pump impeller jammed with food debris, kinked waste hose, or clogged sink siphon adapter nozzle..
How do I fix or resolve FAGOR error code I20?
To resolve error code I20: Clean tub microfilter. Inspect drain pump impeller through sump recess for toothpicks or bones. Check waste hose for kinks or blockages.
Is it safe to clear FAGOR error code I20 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if FAGOR code I20 persists, the physical component causing Drainage timeout: drain pump impeller jammed with food debris, kinked waste hose, or clogged sink siphon adapter nozzle. must be inspected or replaced.
How do I test electrical resistance for FAGOR code I20 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing FAGOR code I20?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



