Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Schaub Lorenz I20
FAQ TREEWhat does error code I20 mean on a Schaub Lorenz appliance?
Schaub Lorenz error code I20 indicates: Schaub Lorenz SLD / AquaStar Integrated & Freestanding Dishwasher: Diagnostic fault code i20 registered by the microcomputer controller. Water not draining from the dishwasher; drain pump blocked or drain hose choked (code i20).
What is the root cause of Schaub Lorenz error code I20?
The primary root cause for Schaub Lorenz code I20 is: On Schaub-Lorenz consumer domestic appliances engineered for German and European households engineered with integrated wash hydraulics, 1850W heating element (27-30 Ω), synchronous wash pump with capacitor (120-150 Ω), 30W magnetic drain pump (160-210 Ω), microswitch float flood tray, and optoelectronic sensor: toothpick or olive pit lodged in pump impeller vanes, sink siphon inlet plugged, or pump winding open. Metrological tolerance verification: drain pump motor winding resistance 160 Ω to 210 Ω at 20°C; pump discharges nominal 15 L/min..
How do I fix or resolve Schaub Lorenz error code I20?
To resolve error code I20: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: clean sump filter meshes, inspect sink spigot nipple and test drain motor winding resistance with ohmmeter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Start/Cancel button for 4 seconds until the display shows '0:01' or drain phase initiates, clearing internal microprocessor error code.
Is it safe to clear Schaub Lorenz error code I20 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Schaub Lorenz code I20 persists, the physical component causing On Schaub-Lorenz consumer domestic appliances engineered for German and European households engineered with integrated wash hydraulics, 1850W heating element (27-30 Ω), synchronous wash pump with capacitor (120-150 Ω), 30W magnetic drain pump (160-210 Ω), microswitch float flood tray, and optoelectronic sensor: toothpick or olive pit lodged in pump impeller vanes, sink siphon inlet plugged, or pump winding open. Metrological tolerance verification: drain pump motor winding resistance 160 Ω to 210 Ω at 20°C; pump discharges nominal 15 L/min. must be inspected or replaced.
How do I test electrical resistance for Schaub Lorenz code I20 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Schaub Lorenz code I20?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



