Faure F110

Faure error code F110 indicates: Faure FCI / FOP Series / Pyrolyse Confort Oven: Door lock position mismatch F110; microswitch sensing signals conflict with commanded lock motor position..

The primary root cause for Faure code F110 is: On Faure (Faure FCI / FOP Series / Pyrolyse Confort Oven) models: Bent microswitch operating arm on lock assembly, cracked cam profile, or loose harness wires swapping position 1 and position 2 feedback lines..

To resolve error code F110: Inspect door lock assembly on top frame. Manually actuate lock cam to verify microswitch contacts toggle cleanly between 0 Ω and ∞ Ω. Press and hold Départ/Pause and Annulation buttons for 6 seconds until all status indicators flash synchronously and clear fault memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faure code F110 persists, the physical component causing On Faure (Faure FCI / FOP Series / Pyrolyse Confort Oven) models: Bent microswitch operating arm on lock assembly, cracked cam profile, or loose harness wires swapping position 1 and position 2 feedback lines. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test 3-Phase Motor Windings / Tacho Generator / Carbon Brushes across Across phase pins U-V, V-W, U-W on motor harness; across tacho pins. Expected nominal reading is 3Ω–6Ω (BLDC phase U-V-W) / 60Ω–180Ω (Tacho coil) / 1.5Ω–3.5Ω (Universal stator). Tolerance: BLDC phase winding values must be strictly balanced within ±0.3Ω. Hand rotation generates 1V–4V AC on tacho..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.