Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Favorit E33
FAQ TREEWhat does error code E33 mean on a Favorit appliance?
Favorit error code E33 indicates: Favorit ProCare / SwissWash High-Efficiency Electronic Washing Machine: Diagnostic fault code E33 registered by the microcomputer controller. Incongruence between electronic analog pressure transmitter and anti-boil pressure switch (code E33).
What is the root cause of Favorit error code E33?
The primary root cause for Favorit code E33 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: mechanical pressure switch contact oxidized, branching manifold tee fitting partially obstructed, or sensor drift. Metrological tolerance verification: mechanical switch closed contact resistance <0.2 Ω at water level >120mm; analog frequency corresponds to level..
How do I fix or resolve Favorit error code E33?
To resolve error code E33: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect plastic T-piece connection, verify continuity of mechanical switch contacts under water fill, check harness. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn cycle selector to Stop. Hold Start/Pause and Eco buttons together for 5 seconds until display chimes and shows 'CLr', wiping diagnostic fault memory.
Is it safe to clear Favorit error code E33 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code E33 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Eco-Inverter BLDC direct drive motor (5.5-8.0 Ω per phase), 2100W heating element (24-27 Ω), 10 kΩ NTC thermistor at 25°C, pneumatic pressure switch with sealed air trap, and instant bi-metal door lock: mechanical pressure switch contact oxidized, branching manifold tee fitting partially obstructed, or sensor drift. Metrological tolerance verification: mechanical switch closed contact resistance <0.2 Ω at water level >120mm; analog frequency corresponds to level. must be inspected or replaced.
How do I test electrical resistance for Favorit code E33 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Favorit code E33?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



