Favorit ER06

Favorit error code ER06 indicates: Favorit SwissBake / CombiSteam Built-in Pyrolytic Convection Oven: Diagnostic fault code ER06 registered by the microcomputer controller. Built-in oven pyrolytic door lock mechanism position feedback microswitch state mismatch (code ER06).

The primary root cause for Favorit code ER06 is: On Favorit SwissLine and European precision appliances built for high durability engineered with PT1000 platinum RTD probe (1080 Ω at 20°C), 2400W convection circular element (22-25 Ω), radial exhaust cooling turbine (160-220 Ω), and motorized door interlock latch: cam actuator arm broken, oxidized switch contacts, or microswitch bracket bent away from rotary cam. Metrological tolerance verification: microswitch closed contact resistance must be <0.2 Ω; open position resistance must be infinite (>10 MΩ)..

To resolve error code ER06: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: manually rotate lock cam to actuate switch, test continuity with ohmmeter in both positions (<0.2 Ω and >10 MΩ). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn temperature knob to Off. Press and hold Clock and Stop buttons for 5 seconds until confirmation tone sounds, wiping error state from EEPROM.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code ER06 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with PT1000 platinum RTD probe (1080 Ω at 20°C), 2400W convection circular element (22-25 Ω), radial exhaust cooling turbine (160-220 Ω), and motorized door interlock latch: cam actuator arm broken, oxidized switch contacts, or microswitch bracket bent away from rotary cam. Metrological tolerance verification: microswitch closed contact resistance must be <0.2 Ω; open position resistance must be infinite (>10 MΩ). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.