Favorit F05_RF

Favorit error code F05_RF indicates: Favorit BioFresh / SwissCool Total NoFrost Inverter Refrigerator: Diagnostic fault code F05_RF registered by the microcomputer controller. Refrigerator evaporator defrost termination NTC temperature sensor circuit open (code F05).

The primary root cause for Favorit code F05_RF is: On Favorit SwissLine and European precision appliances built for high durability engineered with variable-speed inverter compressor (8-12 Ω three-phase), 240W defrost heating glass-tube element (210-280 Ω), 5 kΩ NTC compartment sensors at 25°C, and motorized air distribution damper: thermal cycling in ice pack fractured internal sensor solder joints or harness pin dislodged. Metrological tolerance verification: evaporator NTC resistance nominal 5.0 kΩ at 25°C, 16.5 kΩ at 0°C; resistance >150 kΩ indicates open circuit..

To resolve error code F05_RF: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: unclip sensor clip from aluminum evaporator return bend, unplug harness and test resistance with ohmmeter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Alarm Off and Fridge Temp buttons simultaneously for 5 seconds until digital display flashes '00' and resets cooling microprocessor.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code F05_RF persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with variable-speed inverter compressor (8-12 Ω three-phase), 240W defrost heating glass-tube element (210-280 Ω), 5 kΩ NTC compartment sensors at 25°C, and motorized air distribution damper: thermal cycling in ice pack fractured internal sensor solder joints or harness pin dislodged. Metrological tolerance verification: evaporator NTC resistance nominal 5.0 kΩ at 25°C, 16.5 kΩ at 0°C; resistance >150 kΩ indicates open circuit. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.