Favorit i61

Favorit error code I61 indicates: Favorit SwissLine / DIVA SilentTech Fully Integrated Precision Dishwasher: Diagnostic fault code i61 registered by the microcomputer controller. Dishwasher flow-through water heater surface manual/bimetallic safety thermostat tripped (code i61).

The primary root cause for Favorit code I61 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: wash pump cavitation or water level deficit during heating cycle caused heater tube surface to reach >105°C. Metrological tolerance verification: surface thermostat contact closed resistance <0.2 Ω; opens irreversibly or until manual reset at >105°C..

To resolve error code I61: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: verify water fill level reaches filter rim, test circulation pump pressure, and reset or replace safety thermostat. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Start/Reset button for 4 seconds until drain pump initiates, then turn off power for 60 seconds to clear active error code.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code I61 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: wash pump cavitation or water level deficit during heating cycle caused heater tube surface to reach >105°C. Metrological tolerance verification: surface thermostat contact closed resistance <0.2 Ω; opens irreversibly or until manual reset at >105°C. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.