Favorit iE0

Favorit error code IE0 indicates: Favorit SwissLine / DIVA SilentTech Fully Integrated Precision Dishwasher: Diagnostic fault code iE0 registered by the microcomputer controller. Dishwasher alternative wash zone water distributor diverter valve disk position timeout (code iE0).

The primary root cause for Favorit code IE0 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: diverter synchronous motor gear stripped, position microswitch open, or foreign object jamming rotary disk. Metrological tolerance verification: diverter synchronous drive motor coil resistance 8.5 kΩ to 11.5 kΩ; microswitch closed contact <0.2 Ω..

To resolve error code IE0: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: disconnect diverter harness plug under tub, rotate motor by hand to engage cam and test switch continuity (<0.2 Ω). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Start/Reset button for 4 seconds until drain pump initiates, then turn off power for 60 seconds to clear active error code.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code IE0 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: diverter synchronous motor gear stripped, position microswitch open, or foreign object jamming rotary disk. Metrological tolerance verification: diverter synchronous drive motor coil resistance 8.5 kΩ to 11.5 kΩ; microswitch closed contact <0.2 Ω. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.