Favorit i41

Favorit error code I41 indicates: Favorit SwissLine / DIVA SilentTech Fully Integrated Precision Dishwasher: Diagnostic fault code i41 registered by the microcomputer controller. Dishwasher air trap pressure sensing circuit pneumatic leak detected during wash cycle (code i41).

The primary root cause for Favorit code I41 is: On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: split in silicone pressure tube, loose hose clamp at sensor spigot, or micro-crack in plastic sump nozzle. Metrological tolerance verification: pneumatic circuit pressure decay must be <50 Pa per minute under 2.0 kPa test pressure applied with syringe..

To resolve error code I41: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect silicone tube for pinholes, trim degraded tube ends, reseat firmly onto spigots and clamp securely. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold Start/Reset button for 4 seconds until drain pump initiates, then turn off power for 60 seconds to clear active error code.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Favorit code I41 persists, the physical component causing On Favorit SwissLine and European precision appliances built for high durability engineered with Hydro-Flow wash circulation pump with tachometer (80-120 Ω), 2000W flow-through heater (25-28 Ω), electronic analog pressure transmitter, turbidity optic sensor, and AquaStop base pan float switch: split in silicone pressure tube, loose hose clamp at sensor spigot, or micro-crack in plastic sump nozzle. Metrological tolerance verification: pneumatic circuit pressure decay must be <50 Pa per minute under 2.0 kPa test pressure applied with syringe. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.