Faure i41

Faure error code I41 indicates: Faure FDF Series / Clean&Dry / MaxiWash Dishwasher: Analog pressure sensor signal out of range i41; frequency or voltage exceeds operating window..

The primary root cause for Faure code I41 is: On Faure (Faure FDF Series / Clean&Dry / MaxiWash Dishwasher) models: Pressure switch internal piezoelectric element failure, water entered sensor housing, or corroded connector terminal pins..

To resolve error code I41: Inspect pressure switch pins for green corrosion. Measure output signal with multimeter. Replace analog pressure transducer if defective. Press and hold Départ/Pause and Annulation buttons for 6 seconds until all status indicators flash synchronously and clear fault memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faure code I41 persists, the physical component causing On Faure (Faure FDF Series / Clean&Dry / MaxiWash Dishwasher) models: Pressure switch internal piezoelectric element failure, water entered sensor housing, or corroded connector terminal pins. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.