Faure i43

Faure error code I43 indicates: Faure FDF Series / Clean&Dry / MaxiWash Dishwasher: Dynamic water level fluctuations alarm i43; abnormal pressure oscillations detected during circulation..

The primary root cause for Faure code I43 is: On Faure (Faure FDF Series / Clean&Dry / MaxiWash Dishwasher) models: Spray arms jammed against tall plates or cutlery, lower spray arm clogged with lemon seeds, or foaming from rinse aid overfill..

To resolve error code I43: Ensure upper and lower spray arms rotate freely by hand. Clean clogged spray arm nozzle orifices with a needle. Check for excessive foam. Press and hold Départ/Pause and Annulation buttons for 6 seconds until all status indicators flash synchronously and clear fault memory.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Faure code I43 persists, the physical component causing On Faure (Faure FDF Series / Clean&Dry / MaxiWash Dishwasher) models: Spray arms jammed against tall plates or cutlery, lower spray arm clogged with lemon seeds, or foaming from rinse aid overfill. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.