Haier E8 — Dishwasher
[ACTIVE]Haier I-Pro Shine / Washlogix Ultra Silence Dishwasher: Wash heating circuit failure E8; water fails to heat up, or high-limit safety thermostat opens.
On Haier dishwashers powered by I-Pro Shine Ultra Silence brushless wash circulation pump, dual-zone inverter spray system, and micro-filtration: Open flow-through tubular heating element (~25–32 Ω), burned heater relay contacts on board, or tripped Klixon thermal limiter.
Disconnect heater leads. Measure element resistance (~25–32 Ω across terminals). Test continuity of series safety thermostat. Check solder joints on PCB relay. Press Power button off, hold Half Load and Start buttons together while powering on until diagnostic test mode 01 displays, then power off.



