Hoover F2 — Dryer
[ACTIVE]Hoover H-DRY 300 / 500 Heat-Pump & Auto Care Tumble Dryer: Rear exhaust temperature sensor fault F2; exhaust air probe sends corrupted or out-of-range temperature signal.
On Hoover dryers utilizing H-DRY Auto Care thermodynamic heat-pump circuit, active conductivity sensor bars, and Eco-Power compressor control: Defective rear duct NTC thermistor, damaged sensor wire harness near heater chamber, or connector corrosion.
Check rear duct probe resistance (~10 kΩ–20 kΩ at 25°C). Inspect sensor lead routing to ensure no heat damage from rear element. Turn cycle knob to 0, hold Start/Pause and Anti-Crease buttons for 6 seconds until buzzer beeps three times, then switch to Off.



