Hotpoint F16

Hotpoint error code F16 indicates: Hotpoint ActiveCare & GentlePower Ultima Washing Machine: Drum lock top-loader safety interlock fault F16; microswitch indicates drum gate not secured at spin cycle initiation..

The primary root cause for Hotpoint code F16 is: On Hotpoint top-loading washers: Drum access flap latch not fully clicked into keeper, broken mechanical gate catch, or failed optical sensor beam..

To resolve error code F16: Open top lid and manually confirm positive click-lock of both drum flap latches. Inspect gate spring hinges. Measure gate switch continuity (< 1 Ω closed). Turn cycle knob to 12 o'clock, hold Cancel/Reset for 3 seconds, and power cycle mains switch for 60 seconds.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Hotpoint code F16 persists, the physical component causing On Hotpoint top-loading washers: Drum access flap latch not fully clicked into keeper, broken mechanical gate catch, or failed optical sensor beam. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test PTC Heater Pellet / Pulse Solenoid / Microswitch Contacts across Across PTC heater terminals on lock bezel; switch contact reads <0.2Ω when locked. Expected nominal reading is 800Ω–1.5kΩ (PTC terminals L-N) / 60Ω–120Ω (Pulse Solenoid). Tolerance: ±15%. Switch contacts must read open (OL) when unlocked and 0.0Ω–0.2Ω when fully latched..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.