Hotpoint F36

Hotpoint error code F36 indicates: Hotpoint Active Induction & CleanProtect Cooktop: Front left induction coil NTC sensor calibration drift F36; analog voltage reading indicates out-of-range temperature curve..

The primary root cause for Hotpoint code F36 is: On Hotpoint cooktops: Thermal degradation of sensor bead due to repeated overheating, dry silicone thermal coupling, or moisture on sensor connector..

To resolve error code F36: Measure front left coil NTC resistance: ~100 kΩ at 25°C (falling to ~10 kΩ at 80°C). Clean sensor contact face and renew thermal paste. Replace NTC if drifted. Disconnect mains power for 90 seconds, ensure no cookware rests on sensors, then re-apply power.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Hotpoint code F36 persists, the physical component causing On Hotpoint cooktops: Thermal degradation of sensor bead due to repeated overheating, dry silicone thermal coupling, or moisture on sensor connector. must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.