Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Korting F06_DW
FAQ TREEWhat does error code F06_DW mean on a Korting appliance?
Korting error code F06_DW indicates: Körting KGV / KGI UltraClean Fully Integrated Inverter Dishwasher: Diagnostic fault code F06_DW registered by the microcomputer controller. Dishwasher upper spray arm rotation magnetic sensor missing pulses or arm stalled.
What is the root cause of Korting error code F06_DW?
The primary root cause for Korting code F06_DW is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Asko/Gorenje hydraulic system, 1800W flow heater (27-31 Ω), BLDC wash pump with tachometer (70-95 Ω), magnetic drain pump (150-190 Ω), and turbidity sensor: tall plate or utensil blocking spray arm rotation, magnet missing from arm tip, or reed switch failed. Metrological tolerance verification: reed switch generates 1 pulse per spray arm rotation (~20 to 45 RPM during wash); contact closed <0.3 Ω..
How do I fix or resolve Korting error code F06_DW?
To resolve error code F06_DW: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: check upper rack loading clearance, verify magnet presence on spray arm and pass a magnet over sensor to test continuity. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn appliance off at power button. Hold Program button continuously for 5 seconds while turning power switch On; wait for LED sequence to confirm reset.
Is it safe to clear Korting error code F06_DW by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code F06_DW persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Asko/Gorenje hydraulic system, 1800W flow heater (27-31 Ω), BLDC wash pump with tachometer (70-95 Ω), magnetic drain pump (150-190 Ω), and turbidity sensor: tall plate or utensil blocking spray arm rotation, magnet missing from arm tip, or reed switch failed. Metrological tolerance verification: reed switch generates 1 pulse per spray arm rotation (~20 to 45 RPM during wash); contact closed <0.3 Ω. must be inspected or replaced.
How do I test electrical resistance for Korting code F06_DW using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Korting code F06_DW?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



