Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Korting F13
FAQ TREEWhat does error code F13 mean on a Korting appliance?
Korting error code F13 indicates: Körting KBO / KBE OptiBake Built-in Multifunction & Steam Convection Oven: Diagnostic fault code F13 registered by the microcomputer controller. Oven electronic board cold-junction ambient temperature NTC reference sensor fault.
What is the root cause of Korting error code F13?
The primary root cause for Korting code F13 is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Gorenje OptiBake electronic chassis, PT1000 sensor (1080 Ω at 20°C), 2200W convection circular element (24-27 Ω), 1200W top grill, and tangential cooling blower (180-240 Ω): onboard surface-mount NTC thermistor cracked by thermal shock or solder joint cracked. Metrological tolerance verification: nominal surface NTC resistance 10.0 kΩ at 25°C, 35.0 kΩ at 0°C; smooth resistance curve..
How do I fix or resolve Korting error code F13?
To resolve error code F13: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: inspect electronic board cold junction area for burnt components and measure NTC resistance directly across pads. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn oven selector knob to 0 position. Press and hold Temp and Clock buttons together for 5 seconds until control board beeps, clearing fault record.
Is it safe to clear Korting error code F13 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code F13 persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Gorenje OptiBake electronic chassis, PT1000 sensor (1080 Ω at 20°C), 2200W convection circular element (24-27 Ω), 1200W top grill, and tangential cooling blower (180-240 Ω): onboard surface-mount NTC thermistor cracked by thermal shock or solder joint cracked. Metrological tolerance verification: nominal surface NTC resistance 10.0 kΩ at 25°C, 35.0 kΩ at 0°C; smooth resistance curve. must be inspected or replaced.
How do I test electrical resistance for Korting code F13 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Korting code F13?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



