Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Korting F17_DW
FAQ TREEWhat does error code F17_DW mean on a Korting appliance?
Korting error code F17_DW indicates: Körting KGV / KGI UltraClean Fully Integrated Inverter Dishwasher: Diagnostic fault code F17_DW registered by the microcomputer controller. Dishwasher water softening regeneration valve solenoid coil open circuit (230V AC).
What is the root cause of Korting error code F17_DW?
The primary root cause for Korting code F17_DW is: On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Asko/Gorenje hydraulic system, 1800W flow heater (27-31 Ω), BLDC wash pump with tachometer (70-95 Ω), magnetic drain pump (150-190 Ω), and turbidity sensor: solenoid fine copper winding burned out by continuous activation or terminal lugs corroded. Metrological tolerance verification: regeneration valve solenoid coil resistance 2.2 kΩ to 3.2 kΩ at 20°C; infinite resistance indicates open circuit..
How do I fix or resolve Korting error code F17_DW?
To resolve error code F17_DW: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: gain access to resin water softener tank on left side and measure valve solenoid resistance with digital multimeter. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn appliance off at power button. Hold Program button continuously for 5 seconds while turning power switch On; wait for LED sequence to confirm reset.
Is it safe to clear Korting error code F17_DW by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Korting code F17_DW persists, the physical component causing On Körting domestic and cooking appliances engineered on Gorenje-Hisense platforms engineered with Asko/Gorenje hydraulic system, 1800W flow heater (27-31 Ω), BLDC wash pump with tachometer (70-95 Ω), magnetic drain pump (150-190 Ω), and turbidity sensor: solenoid fine copper winding burned out by continuous activation or terminal lugs corroded. Metrological tolerance verification: regeneration valve solenoid coil resistance 2.2 kΩ to 3.2 kΩ at 20°C; infinite resistance indicates open circuit. must be inspected or replaced.
How do I test electrical resistance for Korting code F17_DW using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Drain Pump Motor Stator Coils across Across pump motor spade terminals (L-N unclipped). Expected nominal reading is 160Ω–220Ω (Sync 230V) / 20Ω–45Ω (3-Phase BLDC). Tolerance: ±10% balance. Insulation resistance between coil and motor chassis must exceed 20MΩ..
What safety protocol must be followed before servicing Korting code F17_DW?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



