Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: LG ER SS
FAQ TREEWhat does error code ER SS mean on a LG appliance?
LG error code ER SS indicates: ABNORMAL WATER-TANK SENSOR. Diagnostic error code Er SS reported on LG Refrigerator..
What is the root cause of LG error code ER SS?
The primary root cause for LG code ER SS is: Water-Tank Sensor short&open circuit.. Internal operating parameter variance or electrical component fatigue on LG..
How do I fix or resolve LG error code ER SS?
To resolve error code ER SS: On LG Refrigerator: 1. Disconnect 230V mains power for 3 minutes. 2. Inspect wire harness and edge connectors on control board for loose pins or oxidation. 3. Inspect mechanical linkages and sensors associated with subsystem. 4. Reset: Press Power to turn off. Unplug mains cable for 5 minutes. Press and hold Start/Pause for 10 seconds to discharge board capacitors, then restart.
Is it safe to clear LG error code ER SS by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if LG code ER SS persists, the physical component causing Water-Tank Sensor short&open circuit.. Internal operating parameter variance or electrical component fatigue on LG. must be inspected or replaced.
How do I test electrical resistance for LG code ER SS using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test PCB Power Supply Rails & DC Bus Filter Capacitors across Across SMPS output electrolytic capacitors on low-voltage side (test bench verification). Expected nominal reading is Low-voltage rails: +5.0V DC (Logic), +12.0V DC (Relays), +3.3V DC (MCU). Relay coils: 200Ω–450Ω.. Tolerance: DC rail ripple must remain <50mV. Direct continuity (0Ω) across DC bus rails indicates dead short..
What safety protocol must be followed before servicing LG code ER SS?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



