Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Midea F24
FAQ TREEWhat does error code F24 mean on a Midea appliance?
Midea error code F24 indicates: Midea Lunar Dial / Crown / Maestro BLDC Inverter Washing Machine & Washer-Dryer: Diagnostic fault code F24 registered by the microcomputer controller. Heating element safety thermal cut-out or dry-fire fusible link open circuit.
What is the root cause of Midea error code F24?
The primary root cause for Midea code F24 is: On Midea appliances engineered with Lunar Dial integrated knob display, high-efficiency BLDC permanent magnet motor, Water Cube stainless drum, and digital frequency level sensor (21-26 kHz): Wash element energized during empty drum condition due to faulty pressure switch, blowing one-shot thermal fuse Metrological tolerance verification: thermal fuse continuity 0.0 Ω when intact, open circuit (> 10 MΩ) when blown (tripped rating 110°C / 16A)..
How do I fix or resolve Midea error code F24?
To resolve error code F24: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: test continuity across thermal limiter terminals embedded in wash heater flange; replace complete heating element assembly if blown. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Turn cycle selector to Off. Press and hold 'Delay End' and 'Spin' (or 'Speed') buttons simultaneously for 5 seconds until 'T01' appears. Turn dial to 'T02' (Fault Memory), press 'Start/Pause' to display stored codes, then hold 'Start/Pause' for 3 seconds until '---' appears to clear all errors. Switch machine off.
Is it safe to clear Midea error code F24 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Midea code F24 persists, the physical component causing On Midea appliances engineered with Lunar Dial integrated knob display, high-efficiency BLDC permanent magnet motor, Water Cube stainless drum, and digital frequency level sensor (21-26 kHz): Wash element energized during empty drum condition due to faulty pressure switch, blowing one-shot thermal fuse Metrological tolerance verification: thermal fuse continuity 0.0 Ω when intact, open circuit (> 10 MΩ) when blown (tripped rating 110°C / 16A). must be inspected or replaced.
How do I test electrical resistance for Midea code F24 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Midea code F24?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?