Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Nardi C10
FAQ TREEWhat does error code C10 mean on a Nardi appliance?
Nardi error code C10 indicates: Nardi PVF / PV43 Touch Control Induction & Electronic Flame Gas Cooktop: Operational diagnostic fault code C10 signaled by internal electronics. Touch control board configuration EEPROM checksum error or corrupted touch parameter table.
What is the root cause of Nardi error code C10?
The primary root cause for Nardi code C10 is: On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Mains spike during flash write, electrical interference from unsuppressed contactor, or IC defect Multimeter diagnostic parameter: stable +5.0V DC logic rail; peak-to-peak noise ripple on touch board VCC rail must remain <40 mV..
How do I fix or resolve Nardi error code C10?
To resolve error code C10: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: verify 5V DC and 3.3V DC voltage regulators on touch PCB and re-flash parameter profile if equipped. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Isolate hob at the electrical fuse board for 90 seconds. Restore power and press the ON/OFF key three times within 5 seconds to clear faults.
Is it safe to clear Nardi error code C10 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Nardi code C10 persists, the physical component causing On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Mains spike during flash write, electrical interference from unsuppressed contactor, or IC defect Multimeter diagnostic parameter: stable +5.0V DC logic rail; peak-to-peak noise ripple on touch board VCC rail must remain <40 mV. must be inspected or replaced.
How do I test electrical resistance for Nardi code C10 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Nardi code C10?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?