Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Nardi C19
FAQ TREEWhat does error code C19 mean on a Nardi appliance?
Nardi error code C19 indicates: Nardi PVF / PV43 Touch Control Induction & Electronic Flame Gas Cooktop: Operational diagnostic fault code C19 signaled by internal electronics. Induction cooling fan motor open circuit, rotor mechanically stalled, or tachometer pulse missing.
What is the root cause of Nardi error code C19?
The primary root cause for Nardi code C19 is: On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Dust accumulation or foreign object obstructing fan impeller, bearing seized, or BLDC driver failed Multimeter diagnostic parameter: 12V DC brushless fan coil resistance nominal 35 Ω to 55 Ω; tachometer generates 2 pulses per revolution..
How do I fix or resolve Nardi error code C19?
To resolve error code C19: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: spin fan blades manually to verify free rotation, then measure 12V DC delivery across fan power leads. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Isolate hob at the electrical fuse board for 90 seconds. Restore power and press the ON/OFF key three times within 5 seconds to clear faults.
Is it safe to clear Nardi error code C19 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Nardi code C19 persists, the physical component causing On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Dust accumulation or foreign object obstructing fan impeller, bearing seized, or BLDC driver failed Multimeter diagnostic parameter: 12V DC brushless fan coil resistance nominal 35 Ω to 55 Ω; tachometer generates 2 pulses per revolution. must be inspected or replaced.
How do I test electrical resistance for Nardi code C19 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Nardi code C19?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?