Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Nardi C29
FAQ TREEWhat does error code C29 mean on a Nardi appliance?
Nardi error code C29 indicates: Nardi PVF / PV43 Touch Control Induction & Electronic Flame Gas Cooktop: Operational diagnostic fault code C29 signaled by internal electronics. Touch slider optical / infrared guide sensor emitter LED open circuit or phototransistor blind.
What is the root cause of Nardi error code C29?
The primary root cause for Nardi code C29 is: On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Infrared LED emitter burned out from continuous current drive, optical light guide displaced, or dust Multimeter diagnostic parameter: infrared emitter forward voltage drop 1.15V to 1.35V DC at 15 mA; phototransistor dark voltage >4.5V DC..
How do I fix or resolve Nardi error code C29?
To resolve error code C29: Safely de-energize the appliance at the electrical distribution board. Unplug wiring connector from the affected component and verify with a digital multimeter: test optical sensor diodes with digital multimeter diode check mode and inspect acrylic light pipe alignment. Inspect spade lugs for signs of heat discoloration. Replace defective component, restore electrical supply, and perform system reset: Isolate hob at the electrical fuse board for 90 seconds. Restore power and press the ON/OFF key three times within 5 seconds to clear faults.
Is it safe to clear Nardi error code C29 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Nardi code C29 persists, the physical component causing On Nardi kitchen suites engineered with planar induction coils, 100 kΩ surface thermistors, IGBT transistors with fast recovery diodes, 12V fan tachometer, and 230V spark pulse generators: Infrared LED emitter burned out from continuous current drive, optical light guide displaced, or dust Multimeter diagnostic parameter: infrared emitter forward voltage drop 1.15V to 1.35V DC at 15 mA; phototransistor dark voltage >4.5V DC. must be inspected or replaced.
How do I test electrical resistance for Nardi code C29 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Nardi code C29?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?