Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Princess ER2
FAQ TREEWhat does error code ER2 mean on a Princess appliance?
Princess error code ER2 indicates: Princess Digital Aerofryer XL / XXL / Deluxe & Double Basket Hot Air Fryer: Diagnostic fault code Er2 registered by the microcomputer controller. Steam Aerofryer water tank reservoir dry or float magnet reed sensor open.
What is the root cause of Princess error code ER2?
The primary root cause for Princess code ER2 is: On Princess appliances engineered with 1800W top calrod heating element, 230V AC high-speed convection fan motor (160 Ω), 100 kΩ NTC air thermistor, and pan insertion microswitch: water reservoir empty, scale stuck magnetic float, or reed switch failed Metrological tolerance verification: magnetic reed switch resistance < 0.5 Ω with water tank filled; open circuit when empty..
How do I fix or resolve Princess error code ER2?
To resolve error code ER2: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: fill reservoir with fresh tap water; free float magnet; test reed switch behind water bay. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: unplug the mains cord for 1 minute, firmly reinsert the drawer basket until the safety interlock clicks, then touch Power for 5 seconds.
Is it safe to clear Princess error code ER2 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Princess code ER2 persists, the physical component causing On Princess appliances engineered with 1800W top calrod heating element, 230V AC high-speed convection fan motor (160 Ω), 100 kΩ NTC air thermistor, and pan insertion microswitch: water reservoir empty, scale stuck magnetic float, or reed switch failed Metrological tolerance verification: magnetic reed switch resistance < 0.5 Ω with water tank filled; open circuit when empty. must be inspected or replaced.
How do I test electrical resistance for Princess code ER2 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Princess code ER2?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?