Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Scholtès A01
FAQ TREEWhat does error code A01 mean on a Scholtès appliance?
Scholtès error code A01 indicates: Scholtès LTE / LPE Maxi Plate 14-Place Integrated Dishwasher: Diagnostic fault code A01 registered by the microcomputer controller. Anti-flood float switch triggered in base tray / leak detected.
What is the root cause of Scholtès error code A01?
The primary root cause for Scholtès code A01 is: On Scholtès appliances engineered with EVO-3 / Arcadia hydraulic control platform with variable-frequency wash pump, active siphonage detection, and calibrated NTC immersion thermistor: water in bottom drip pan lifting polystyrene float Metrological tolerance verification: microswitch continuity 0.0 Ω closed (normal), open triggered...
How do I fix or resolve Scholtès error code A01?
To resolve error code A01: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: drain base pan, inspect hose joints for leaks, and test float switch. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold the P (Program) and Start buttons simultaneously for 4 seconds until all LEDs illuminate and the machine emits a beep, then turn selector to 0 to cancel the error.
Is it safe to clear Scholtès error code A01 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Scholtès code A01 persists, the physical component causing On Scholtès appliances engineered with EVO-3 / Arcadia hydraulic control platform with variable-frequency wash pump, active siphonage detection, and calibrated NTC immersion thermistor: water in bottom drip pan lifting polystyrene float Metrological tolerance verification: microswitch continuity 0.0 Ω closed (normal), open triggered.. must be inspected or replaced.
How do I test electrical resistance for Scholtès code A01 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Scholtès code A01?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



