Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Scholtès F3
FAQ TREEWhat does error code F3 mean on a Scholtès appliance?
Scholtès error code F3 indicates: Scholtès Dynamic Air Cooling & Total No-Frost Built-in Refrigerator: Diagnostic fault code F3 registered by the microcomputer controller. Freezer compartment air temperature NTC sensor failure.
What is the root cause of Scholtès error code F3?
The primary root cause for Scholtès code F3 is: On Scholtès appliances engineered with Dynamic Air Cooling airflow with multi-sensor evaporator defrost cycle, bi-stable refrigerant distribution valve, and high-efficiency hermetic compressor: freezer air sensor open circuit Metrological tolerance verification: nominal 2.7 kΩ at 25°C, 28.0 kΩ at -18°C...
How do I fix or resolve Scholtès error code F3?
To resolve error code F3: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure probe terminals at connector X4 on main PCB. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press the Holiday / Eco mode and Fast Freeze buttons simultaneously for 5 seconds until the display flashes twice and the audible alarm silences.
Is it safe to clear Scholtès error code F3 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Scholtès code F3 persists, the physical component causing On Scholtès appliances engineered with Dynamic Air Cooling airflow with multi-sensor evaporator defrost cycle, bi-stable refrigerant distribution valve, and high-efficiency hermetic compressor: freezer air sensor open circuit Metrological tolerance verification: nominal 2.7 kΩ at 25°C, 28.0 kΩ at -18°C.. must be inspected or replaced.
How do I test electrical resistance for Scholtès code F3 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing Scholtès code F3?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



