Scholtès Refrigerator / Freezer F9E2

Scholtès error code F9E2 indicates: Scholtès Pure Cold Built-in Total NoFrost Refrigerator: Diagnostic code F9E2 indicates ice maker mold release heater failure; ejector blades stall attempting to harvest unreleased cubes..

The primary root cause for Scholtès code F9E2 is: On Scholtès refrigerators (Scholtès Haute Horlogerie Culinaire sensors and micro-electronic platform architecture): Open circuit in mold bottom calrod heater or blown internal thermal fuse. Heater resistance: 65–95 Ω (115V) or 250–380 Ω (230V)..

To resolve error code F9E2: Disconnect power. Disassemble front cover of ice maker. Measure mold heater resistance across test points L and H: expect 65–95 Ω (115V) or 250–380 Ω (230V). If circuit reads infinite Ω, replace ice maker assembly. Press and hold Alarm Reset pad for 5 seconds, verify compartment display stops blinking, and allow 12h for complete stabilization.

Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Scholtès code F9E2 persists, the physical component causing On Scholtès refrigerators (Scholtès Haute Horlogerie Culinaire sensors and micro-electronic platform architecture): Open circuit in mold bottom calrod heater or blown internal thermal fuse. Heater resistance: 65–95 Ω (115V) or 250–380 Ω (230V). must be inspected or replaced.

Set a digital multimeter to ohms (Ω). Disconnect power and test Immersion / Air Heating Element & Klixon Thermostat across Between element terminals (unwired). Insulation to earth casing: >20MΩ (OL). Expected nominal reading is 25Ω–28Ω (230V / 2000W) / <0.5Ω (Safety Klixon closed). Tolerance: Formula R = V²/P (±5%). Any earth leakage reading below 2MΩ will trip the domestic 30mA RCD breaker..

Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.