Siemens E01 — Dishwasher
[ACTIVE]Siemens iQ300 / iQ500 / iQ700 / iQ800 studioLine Zeolith & varioSpeed Plus: Critical power module failure E01; heating circuit relay contacts open or welded on the main control board.
On Siemens dishwashers: Relay driver triac damaged by heater inrush current, high contact resistance, or cold solder joints on the power board.
Disconnect mains power. Inspect power module in bottom right base. Measure heater resistance (nominal 19–22 Ω). Replace power module if relay is burnt. Press and hold Start button for 4 seconds until display indicates '0:01', wait for evacuation pump, then power off.



