Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Zephir HP01
FAQ TREEWhat does error code HP01 mean on a Zephir appliance?
Zephir error code HP01 indicates: Zephir Air-to-Water & Sanitary Thermodynamic Heat Pump: Diagnostic fault code HP01 registered by the microcomputer controller. Hydronic heating water flow switch contact open circuit during pump operation.
What is the root cause of Zephir error code HP01?
The primary root cause for Zephir code HP01 is: On Zephir appliances engineered with Zephir thermodynamic hydronic module, stainless steel plate condenser, paddle flow switch (closed < 1 Ω), and dual high/low refrigerant pressure switches: hydronic water flow switch contact open circuit (< 1.0 Ω closed under flow) due to low flow rate or air pockets Metrological tolerance verification: flow switch contact continuity < 1.0 Ω when water flow exceeds 600 L/h..
How do I fix or resolve Zephir error code HP01?
To resolve error code HP01: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: clean Y-strainer filter mesh, purge air from heating circuit, and measure switch continuity. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: On the digital wall-mounted controller: hold 'PWR' and 'SET' together for 4 seconds until 'CLR' appears on the display. Scroll to 'Fault Log', hold 'OK' for 3 seconds to clear codes. Switch off the 230V mains breaker for 60 seconds to reset safety relays.
Is it safe to clear Zephir error code HP01 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Zephir code HP01 persists, the physical component causing On Zephir appliances engineered with Zephir thermodynamic hydronic module, stainless steel plate condenser, paddle flow switch (closed < 1 Ω), and dual high/low refrigerant pressure switches: hydronic water flow switch contact open circuit (< 1.0 Ω closed under flow) due to low flow rate or air pockets Metrological tolerance verification: flow switch contact continuity < 1.0 Ω when water flow exceeds 600 L/h. must be inspected or replaced.
How do I test electrical resistance for Zephir code HP01 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Mechanical Pressure Switch Contacts / Inductive Frequency Sensor across Across switch spade contacts with harness unplugged; electronic output: 40Hz–50Hz frequency signal. Expected nominal reading is Mechanical: Continuity 0.0Ω–0.2Ω (Empty: 11-12, Full: 11-14). Electronic: 20Ω–45Ω coil resistance.. Tolerance: Mechanical switch contacts must transition cleanly on gentle breath pressure. Coil ~22Ω ±5%..
What safety protocol must be followed before servicing Zephir code HP01?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



