Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Zephir HP03
FAQ TREEWhat does error code HP03 mean on a Zephir appliance?
Zephir error code HP03 indicates: Zephir Air-to-Water & Sanitary Thermodynamic Heat Pump: Diagnostic fault code HP03 registered by the microcomputer controller. Hydronic heating primary water inlet temperature thermistor NTC fault.
What is the root cause of Zephir error code HP03?
The primary root cause for Zephir code HP03 is: On Zephir appliances engineered with Zephir thermodynamic hydronic module, stainless steel plate condenser, paddle flow switch (closed < 1 Ω), and dual high/low refrigerant pressure switches: water inlet temperature NTC thermistor fault (NTC 10 kΩ at 25°C) open or shorted Metrological tolerance verification: NTC thermistor 10 kΩ at 25°C, 32.5 kΩ at 0°C, 3.5 kΩ at 60°C..
How do I fix or resolve Zephir error code HP03?
To resolve error code HP03: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: disconnect probe at hydrobox control board and measure resistance across pins. Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: On the digital wall-mounted controller: hold 'PWR' and 'SET' together for 4 seconds until 'CLR' appears on the display. Scroll to 'Fault Log', hold 'OK' for 3 seconds to clear codes. Switch off the 230V mains breaker for 60 seconds to reset safety relays.
Is it safe to clear Zephir error code HP03 by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Zephir code HP03 persists, the physical component causing On Zephir appliances engineered with Zephir thermodynamic hydronic module, stainless steel plate condenser, paddle flow switch (closed < 1 Ω), and dual high/low refrigerant pressure switches: water inlet temperature NTC thermistor fault (NTC 10 kΩ at 25°C) open or shorted Metrological tolerance verification: NTC thermistor 10 kΩ at 25°C, 32.5 kΩ at 0°C, 3.5 kΩ at 60°C. must be inspected or replaced.
How do I test electrical resistance for Zephir code HP03 using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test NTC Temperature Sensor Probe (Thermistor) across Across sensor pins 1-2 (unplugged harness). Expected nominal reading is 4.8kΩ–12kΩ (at 20°C–25°C). Tolerance: Negative temperature coefficient: resistance drops smoothly when warmed with fingers. OL = open circuit..
What safety protocol must be followed before servicing Zephir code HP03?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



