Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Airlux AL
FAQ TREEWhat does error code AL mean on a Airlux appliance?
Airlux error code AL indicates: Airlux Horizon Total No-Frost Integrated Built-in Refrigerator: Diagnostic fault code AL registered by the microcomputer controller. Door ajar alarm timeout exceeded (> 3 minutes)..
What is the root cause of Airlux error code AL?
The primary root cause for Airlux code AL is: On Airlux appliances engineered with Horizon multi-duct cooling column, automated defrost heating element, and hermetic inverter compressor: refrigerator or freezer door left open or switch stuck. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 2.5 kΩ at 60°C..
How do I fix or resolve Airlux error code AL?
To resolve error code AL: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure sensor resistance across 2-pin harness connector (expected ~10 kΩ at 25°C). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Press and hold the Freezer Temperature and Fast Cooling keys simultaneously for 5 seconds until a confirmation chime sounds, resetting internal temperature alarms and error indicators.
Is it safe to clear Airlux error code AL by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Airlux code AL persists, the physical component causing On Airlux appliances engineered with Horizon multi-duct cooling column, automated defrost heating element, and hermetic inverter compressor: refrigerator or freezer door left open or switch stuck. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 2.5 kΩ at 60°C. must be inspected or replaced.
How do I test electrical resistance for Airlux code AL using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing Airlux code AL?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



