Field Actions
DISPATCHAlways disconnect appliance from 230V/400V mains before opening panels. Use CAT III multimeter for circuit testing.
Frequently Asked Questions: Foster AL
FAQ TREEWhat does error code AL mean on a Foster appliance?
Foster error code AL indicates: Foster Milano / S4000 Integrated Total No-Frost Refrigerator and Wine Cellar: Diagnostic fault code AL registered by the microcomputer controller. Door ajar alarm timeout exceeded (> 3 minutes)..
What is the root cause of Foster error code AL?
The primary root cause for Foster code AL is: On Foster appliances engineered with dual evaporator multi-temperature refrigeration circuit, digital BLDC variable speed compressor, and electronic humidity control for wine preserving: refrigerator or freezer door left open or switch stuck. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 2.5 kΩ at 60°C..
How do I fix or resolve Foster error code AL?
To resolve error code AL: Disconnect mains power before servicing. Unplug the harness at the main PCB and use a calibrated digital multimeter: measure sensor resistance across 2-pin harness connector (expected ~10 kΩ at 25°C). Inspect contacts for pin oxidation or loose terminals. Replace defective part if out of tolerance, re-energize and clear error: Touch and hold the Alarm Reset and Temperature Adjustment sensors simultaneously for 6 seconds until the digital readout stops blinking and beeps twice, resetting the internal microcomputer fault buffer.
Is it safe to clear Foster error code AL by resetting power?
Resetting power (unplugging for 5–10 minutes) clears temporary memory errors. However, if Foster code AL persists, the physical component causing On Foster appliances engineered with dual evaporator multi-temperature refrigeration circuit, digital BLDC variable speed compressor, and electronic humidity control for wine preserving: refrigerator or freezer door left open or switch stuck. Metrological tolerance verification: nominal NTC thermistor 10.0 kΩ at 25°C, 2.5 kΩ at 60°C. must be inspected or replaced.
How do I test electrical resistance for Foster code AL using a multimeter?
Set a digital multimeter to ohms (Ω). Disconnect power and test Compressor Motor Windings (Run/Start) & Defrost Heater across Across 3 compressor pins (Common, Run, Start): R(C-S) + R(C-R) = R(S-R). Winding to earth: >20MΩ (OL).. Expected nominal reading is 15Ω–25Ω (Run C-R), 20Ω–35Ω (Start C-S), 200Ω–400Ω (Defrost Heater). PTC Relay: 10Ω–30Ω at 25°C.. Tolerance: ±10%. Any low insulation resistance to casing (<2MΩ) trips the breaker. Defrost bimetal reads <0.5Ω when sub-zero..
What safety protocol must be followed before servicing Foster code AL?
Standard electrical safety protocol: 1. Disconnect 230V mains power before opening panels. 2. Verify zero voltage at test points. 3. Allow hot water or heating elements to cool below 30°C before handling.
Community Verification
COMMUNITYDid this solution resolve the issue?



